De
ballonfigurensite
Hier leer je alles over ballonvouwen |
De dinohoed - The dino hat |
|
Maak stap voor stap ballonhoeden -- Make
step by step balloon hats
Wederom veel dank voor Willempie voor dit makkelijk te maken, maar erg leuke voorbeeld. |
1: Blaas een ballon op 2
cm na op. Maak een bubbel van plm. 5 cm en twee
van 2 cm.
2: Twist de twee bubbels
van 2 cm in elkaar, je hebt nu een dinosaurus
kop en dinosaurus oren.
3: Knoop het einde van de
rest van de ballon pas om het kind zijn hoofd.
4: Om de kop extra recht
omhoog te steken maak onder in de nek een 2cm
bubbel en doe daar een pinchtwist in. Dit hoeft
niet, maar de kop steekt dan mooier omhoog.
Zonder werkt ook goed.
5: Blaas de volgende
ballon op 4 cm na op. Twist de tweede ballon in
dit punt in.
6: Twist drie middelgrote
loops op plm 1/3, de helft en 2/3 deel van de
boog over de hoed.
7: Extra voorbeeld van
deze loop.
8: Twist het einde op plm.
5 cm (of wat bij de verhoudingen past) in het
midden van de boog vast en klaar is de dinohoed.
|
1 |
2 |
3 |
|
|
|
4 |
5 |
6 |
|
|
|
7 |
8 |
|
|
|
|
1: Blow up a balloon, leave 2 cm empty. Create a
bubble of approx. 5 cm, and two of 2 cm.
2: Twist the two bubbles of 2 cm in each other,
you now have a dinosaur dinosaur head and ears.
3: Tie the end of the rest of the balloon only
at the child's head.
4: If you want the head extra straight up to
make stabbing in the neck a 2cm bubble and add a
pinch twist.
5: Blow up the balloon , leave 4 cm empty. Twist
the second balloon at this point.
6: Twist three medium loops at approx 1/3, half
and 2/3 part of the bow on the hat.
7: Additional example of this loop.
8: Twist the end at approx. 5 cm (or which is at
the appropriate ratios) in the center of the
arc-proof and is ready dino the hat.
|
|
|
|